CO2 TRAP 100CC 1/8IN FITTINGS (C15-1304-168)

General description

Sodium hydroxide nonfibrous silicate material is universally accepted for its high absorptive capacity and indicating properties for carbon dioxide. Typically, this material will absorb 20-30% of its weight in carbon dioxide before replacement of the saturated material is required. As carbon dioxide is absorbed, the greenish-brown material turns white because of the formation of sodium carbonate. The trap body is constructed of borosilicate glass, and the fittings are nickel-plated and have sintered stainless steel frits.

A moisture trap should be installed downstream from this unit to absorb the moisture that is produced.

Note: Exercise extreme caution when refilling the trap due to the caustic nature of the absorbent.

Dimensions:

• 100 cc Traps: 123/4 in. (32.4 cm) long x 13/4 in. (44 mm) diameter
• 250 cc Traps: 171/2 in. (44.4 cm) long x 2 in. (51 mm) diameter

Application

It may be used to connect combustion oven and GCMS separator, for transfer of the gas into MS inlet system which monitors isotope-ratio.

volume: 100 . cc . fitting: 1/8 in. fitting. Pictograms: GHS05. Signal Word: Danger. Hazard Statements: H290 - H314. Precautionary Statements: P234 - P260 - P280 - P303 + P361 + P353 - P304 + P340 + P310 - P305 + P351 + P338. Hazard Classifications: Eye Dam. 1 - Met. Corr. 1 - Skin Corr. 1A. Storage Class Code: 8B - Non-combustible, corrosive hazardous materials. WGK: WGK 3. Flash Point(F): Not applicable. Flash Point(C): Not applicable. Personal Protective Equipment: Eyeshields, Faceshields, Gloves, type P3 (EN 143) respirator cartridges.