EDTA Antigen Retrieval Solution

Aladdin's EDTA Antigen Retrieval Solution is commonly used for antigen retrieval of paraffin sections, frozen sections and other samples after fixation using paraformaldehyde, formaldehyde or other aldehyde reagents.This product employs the widely used EDTA, which can effectively remove cross-linking between proteins caused by aldehyde fixation reagents and fully expose epitopes in samples such as paraffin sections, thereby greatly improving the immunostaining effect.Normally, paraffin sections require antigen retrieval, whereas frozen sections can be stained without antigen retrieval. This product is particularly suitable for paraffin sections, but can also be used for other samples such as frozen sections.For the features and comparison of various Antigen Retrieval Solutions from aladdin, please refer to the following websitePrecautions：The antigen retrieval can be performed in staining jars with staining racks or mailing clips. Plastic staining jars, staining racks and mailing clips can withstand boiling water very well, while glass ones are easily broken due to sudden cold or heat.This product must be diluted 50 times with ddH2O or Milli-Q water prior to use.This product is for R&D only. Not for drug, household, or other uses.For your safety and health, please wear a lab coat and disposable gloves during the operation.Instructions for Use：1. Antigen retrieval of paraffin sections.a. Dewaxing: Dewax the section in xylene for 5 min and then replace with fresh xylene for a total of 3 dewaxes. Then immerse the section in absolute ethanol for 5 min, twice; 90% ethanol for 5 min, twice; 70% ethanol for 5 min, once; and distilled water for 5 min, twice.b. Antigen retrieval: Dilute this product with ddH2O or Milli-Q water at 1:50 to obtain the Antigen Retrieval Solution (1X). Immerse the sections in Antigen Retrieval Solution (1X) and heat at 95-100ºC for approximately 20 minutes (The heating time can be within 10-30 minutes, depending on the sample and the target protein). The Antigen Retrieval Solution (1X) should be preheated to 95-100ºC before use, either in a normal water bath or in a microwave oven. If using microwave, care needs to be taken to avoid flash boiling and excessive water evaporation. Then cool to room temperature in approximately 20-30 minutes. Wash 1-2 times with Immunostaining Wash Buffer for 3-5 minutes each time. Subsequent immunostaining steps such as blocking can then be performed.2. Antigen retrieval of frozen sections.Wash the sections with Immunostaining Wash Buffer for 5 minutes. Immerse the sections in Antigen Retrieval Solution (1X) and heat at 95-100ºC for approximately 20 minutes (The heating time can be within 10-30 minutes, depending on the sample and the target protein). The Antigen Retrieval Solution (1X) should be preheated to 95-100ºC before use, either in a normal water bath or in a microwave oven. If using microwave, care needs to be taken to avoid flash boiling and excessive water evaporation. Then cool to room temperature in approximately 20-30 minutes. Wash 1-2 times with Immunostaining Wash Buffer for 3-5 minutes each time. Subsequent immunostaining steps such as blocking can then be performed.3. For antigen retrieval in other samples, refer to the above procedures for either paraffin sections or frozen sections.

Specification: 50X