Lab Tubing

Microscale sublimation adapter for use with 9591-21 Vial and 9592-10 Flask. Supplied with 14/10 inner joint. Hose connection is size A.

Length in millimeters refers to the effective length of the column as measured from the lowest to the highest indent of the column. Available in a microscale version, top center joint is 14/10 externally threaded for making an O-Ring-Cap-Seal type

Distilling trap adapter with standard taper joints.

With two standard taper 14/20 outer joints, one 7 mm drip tube.

With inner and outer joints at bottom and top. Available with #7 Ace-Thred and Ace-Safe PTFE hose connections on inlet and outlet with barb for 1/4 I.D. tubing.";MPN=9297-106"

With inner and outer joints at bottom and top. Available with #7 Ace-Thred and Ace-Safe PTFE hose connections on inlet and outlet with barb for 1/4 I.D. tubing.";MPN=9297-05"

Tubing is same diameter as reinforcing rings on the standard taper joint. The rings permit penetration by the clamp cushioning material, and permit firm support without the need for excessive pressure on the joint also, strain on the joint is

Sparger tube for use in #15 Ace-Thred with either ONE-PIECE or TWO-PIECE Reactors. Consists of a closed bottom, 1/2 I.D. bore. Bottom of tube has two 3/64 male thread for connecting to bot

14x500'x.006 Tubing, CE-Force LDFPE Level 100 Clean, 500FT

15 mL Conical Tube Adapters for Conical Buckets (set of 2) - Benchtop Centrifuges, MISTT

15 x 1.5ml Tube Block for Dry Bath

15 x 2.0ml Tube Block for Dry Bath