-
7585-16Medium length joints available in a variety of sizes both inner and outer members.
-
5420-23Guy-Lussac type unadjusted for calibration in the laboratory. When adjusted, suitable for ASTM D 369. Stopper and bottle available separately.
-
8300-05PTFE adapter with FETFE O-Ring for use with plain stem thermometers, gas inlet tubes, etc. O-Ring compression seal allows adjustable depth positioning.
-
9099-08A special well fabricated from glass that is worked to a very thin wall for better heat transfer. Fabricated in two sizes for either 25mm or 76mm immersion, length of tube being measured from the bottom of the ground joint.
-
9099-12A special well fabricated from glass that is worked to a very thin wall for better heat transfer. Fabricated in two sizes for either 25mm or 76mm immersion, length of tube being measured from the bottom of the ground joint.
-
7565-12Standard taper inner member ground joint for use with outer members listed under Catalog number 7565, 7566, 7567, 7651 and 7652. Can also be used with half joints listed under 7568 and 7585.
-
7640-02Standard taper ioint with lower tube reduced in diameter to size listed. Length of extended tube 101mm.
-
7630-04Standard taper joint with reduced tube at both ends. Length of tube below joint is 100mm.
-
7651-02Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.
-
7566-13Tubing is same diameter as reinforcing rings on the standard taper joint. The rings permit penetration by the clamp cushioning material, and permit firm support without the need for excessive pressure on the joint also, strain on the joint is
-
7567-13O.D. of standard taper joint and tube are approximately same size, allowing for ease in clamping.
-
7651-04Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.