Supplies

Standard taper joint with reduced tube at both ends. Length of tube below joint is 100mm.

Standard taper inner member ground joint with groove for O-Ring. For use with outer members 7565, 7566, 7567, 7651, and 7652.

Tubing is same diameter as reinforcing rings on the standard taper joint. The rings permit penetration by the clamp cushioning material, and permit firm support without the need for excessive pressure on the joint also, strain on the joint is

O.D. of standard taper joint and tube are approximately same size, allowing for ease in clamping.

Designed for use with inner member regular joints with only a slight mismatch. Treated on inner surface so that it may be cemented to glass with ACE 7560 epoxy adhesive.

Full length glass stoppers available in a variety of joint sizes. Joint sizes 7/25 and 10/30 are solid glass, others sizes are hollow glass.

With 75 degree angle standard taper joints.

With ACE fritted disc. Porosities A, B, C and D are priced the same.

Used for drying air-sensitive compounds with inert gas or a simple pressure filter funnel. O-Ring joint connects cap to body to give a larger opening.

With ACE fritted disc. Porosities A, B, C and D are priced the same.

Used for drying air-sensitive compounds with inert gas or a simple pressure filter funnel. O-Ring joint connects cap to body to give a larger opening.

With ACE fritted disc. Porosities A, B, C and D are priced the same.