Glass

Standard taper joint with reduced tube at both ends. Length of tube below joint is 100mm.

Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.

Tubing is same diameter as reinforcing rings on the standard taper joint. The rings permit penetration by the clamp cushioning material, and permit firm support without the need for excessive pressure on the joint also, strain on the joint is

O.D. of standard taper joint and tube are approximately same size, allowing for ease in clamping.

Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.

Designed for use with inner member regular joints with only a slight mismatch. Treated on inner surface so that it may be cemented to glass with ACE 7560 epoxy adhesive.

Connecting adapter with top female and bottom male standard taper joints.

Thread for replacement on apparatus using G.P.

Jacketed filter reactor systems with all you need to perform single or multi-step reactions and filtrations in the same vessel. Systems with Ace-Thred heads are pressure rated to 35 psi at 100 degrees C.

Jacketed filter reactor systems with all you need to perform single or multi-step reactions and filtrations in the same vessel. Systems with Ace-Thred heads are pressure rated to 35 psi at 100 degrees C.

Jacketed filter reactor systems with all you need to perform single or multi-step reactions and filtrations in the same vessel. Systems with Ace-Thred heads are pressure rated to 35 psi at 100 degrees C.

Jacketed filter reactor systems with all you need to perform single or multi-step reactions and filtrations in the same vessel. Systems with Ace-Thred heads are pressure rated to 35 psi at 100 degrees C.