Glass Joints

Glass standard taper joint adapters featuring a drip tip and a vertical ground glass tube sidearm. The sidearm is used to make tube compression fitting connection to a wide variety of flexible and rigid tubing using our 12709,12711,12715 & 12716

Glass standard taper joint adapters featuring a drip tip and a vertical ground glass tube sidearm. The sidearm is used to make tube compression fitting connection to a wide variety of flexible and rigid tubing using our 12709,12711,12715 & 12716

Glass standard taper joint adapters featuring a drip tip and a vertical ground glass tube sidearm. The sidearm is used to make tube compression fitting connection to a wide variety of flexible and rigid tubing using our 12709,12711,12715 & 12716

Glass standard taper joint adapters featuring a drip tip and a vertical ground glass tube sidearm. The sidearm is used to make tube compression fitting connection to a wide variety of flexible and rigid tubing using our 12709,12711,12715 & 12716

Glass standard taper joint adapters featuring a drip tip and a vertical ground glass tube sidearm. The sidearm is used to make tube compression fitting connection to a wide variety of flexible and rigid tubing using our 12709,12711,12715 & 12716

Y shaped, 3-way adpater. One outer joint, two inner standard taper joints. Great for adapting flasks and other Schlenk line components. All three joints are the same size.

Y shaped, 3-way adpater. One outer joint, two inner standard taper joints. Great for adapting flasks and other Schlenk line components. All three joints are the same size.

Three way, Y shaped adapter. 2-outer standard taper joints, 1-inner standard taper joint. All three the same size. Great for joining flasks and other components for Schlenk lines.

Three way, Y shaped adapter. 2-outer standard taper joints, 1-inner standard taper joint. All three the same size. Great for joining flasks and other components for Schlenk lines.

This bushing adapter has a male Ace-Thred connection at bottom and a female NPT thread drilled into the center of the top of the bushing. The top FNPT connection matches male Swagelok fittings and facilitates joining plastic or metal tubing to

Adapter has a coarse frit sealed between the #15 o-ring joint and the standard taper inner joint. Frit permits filtration of large particles before introduction into the flask and also serves as a bump trap for reactions being performed in flasks

Adapters for use with AF-0060 thru AF-0062 vacuum manifolds that permit the manifold to be utilized with a multitude of standard glassware or tubing products. The AF-0070 adapters are to be used with either a Cajon&reg fitting on the main ports or