Glass Joints

All pipe is available from stock in lengths shown special lengths available at slightly higher cost.

A potential metabolite of PGD2, presumably produced from the known metabolite 13,14-dihydro-15-keto PGD2.

Used as a one-time opening valve. Drawn to a point so that a small weight will fracture the seal.

Snap Seal vials can accept aluminum crimp seals or Snap Top Caps. 2701H01 through H22 are aluminum seals, 13 mm with Septa 2701H25 through H58 are Snap Top Caps, 13 mm with Septa. 2701H61 through H82 fit Shimadzu autosamplers.

Snap Seal vials can accept aluminum crimp seals or Snap Top Caps. 2701H01 through H22 are aluminum seals, 13 mm with Septa 2701H25 through H58 are Snap Top Caps, 13 mm with Septa. 2701H61 through H82 fit Shimadzu autosamplers.

Standard taper inner ground joints used in fabrication of ACE Microscale Glassware. Use with 7609 outer member. Codes -11, -12 and -13 have drip tip.

Standard taper outer ground joints with external thread for making an O-RING-CAP SEAL connection with mating 7608 inner joint. Used in fabricating ACE Microscale Glassware. Joints not supplied with cap or O-Ring, see 9590 and 7855.

Standard taper outer ground joints with external thread for making an O-RING-CAP SEAL connection with mating 7608 inner joint. Used in fabricating ACE Microscale Glassware. Joints not supplied with cap or O-Ring, see 9590 and 7855.

Microscale sublimation adapter for use with 9591-21 Vial and 9592-10 Flask. Supplied with 14/10 inner joint. Hose connection is size A.

A special well fabricated from glass that is worked to a very thin wall for better heat transfer. Fabricated in two sizes for either 25mm or 76mm immersion, length of tube being measured from the bottom of the ground joint.

With condenser jacket on side arm. Thermometer joint is 10/30 (see 8315 for thermometer listing). Side arm is at a 75 degree angle.

With condenser jacket on side arm. Thermometer joint is 10/30 (see 8315 for thermometer listing). Side arm is at a 75 degree angle.