Glass Joints

Borosilicate glass transition adapter to convert beaded pipe 2 to standard taper joint.

Borosilicate glass transition adapter to convert beaded pipe 2 to standard taper joint.

Standard taper inner joint with an unconstricted 30 degree angle drip tip extending from bottom of joint.

Standard taper ioint with lower tube reduced in diameter to size listed. Length of extended tube 101mm.

Standard taper joint with reduced tube at both ends. Length of tube below joint is 100mm.

Standard taper inner and outer lengths tooled on longer lengths or different sizes than normally available under part numbers CG-100 through CG-105. These joints offer the glassblower the opportunity to construct apparatus made of heavier tubing or

Standard taper inner and outer lengths tooled on longer lengths or different sizes than normally available under part numbers CG-100 through CG-105. These joints offer the glassblower the opportunity to construct apparatus made of heavier tubing or

Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.

Interchangeable, full length. These joints are machined from 18-8 type 303 free machining Stainless Steel and are supplied in accordance with CS21-58 of the N.

Standard taper inner joint with extending tube reduced in diameter.

Similar to CG-170, but with a drip tip cut at a 45&deg angle.

Standard taper inner member ground joint with groove for O-Ring. For use with outer members 7565, 7566, 7567, 7651, and 7652.