Glass Joints

Standard taper, outer member, medium length, straight-sided joint.

Medium length joints available in a variety of sizes both inner and outer members.

Standard taper inner member ground joint for use with outer members listed under Catalog number 7565, 7566, 7567, 7651 and 7652. Can also be used with half joints listed under 7568 and 7585.

Standard taper ioint with lower tube reduced in diameter to size listed. Length of extended tube 101mm.

O.D. of standard taper joint and tube are approximately same size, allowing for ease in clamping.

Tubing is same diameter as reinforcing rings on the standard taper joint. The rings permit penetration by the clamp cushioning material, and permit firm support without the need for excessive pressure on the joint also, strain on the joint is

Standard taper inner and outer lengths tooled on longer lengths or different sizes than normally available under part numbers CG-100 through CG-105. These joints offer the glassblower the opportunity to construct apparatus made of heavier tubing or

Designed for use with inner member regular joints with only a slight mismatch. Treated on inner surface so that it may be cemented to glass with ACE 7560 epoxy adhesive.

Sparger tube for use in #15 Ace-Thred with either ONE-PIECE or TWO-PIECE Reactors. Consists of a closed bottom, 1/2 I.D. bore. Bottom of tube has two 3/64 male thread for connecting to bot

Full length, standard wall. U.S. Reissue Patent No. 22181. These famous ACE spherical joints are precision ground and vacuum leak-tested for fit and interchangeability. Available in both ball and socket members.

With standard taper outer or spherical socket joint at one end and a hose connection at the other end.

Recommended for use with PTFE-Clad ball member. Polished surface does not wear PTFE, assures more precise fit than the standard ground surface.