Tools

The 5 cm nitrous oxide burner head is required for nitrous oxide-acetylene operation. This burner head can also be used with air-acetylene or rotated to provide reduced sensitivity.

A 5 cm air-acetylene burner head is available for applications in which reduced sensitivity is required. It can be rotated to provide further sensitivity reduction, and it has a wide slot to prevent clogging.

It is used for driving the pneumatic valves of the PerkinElmer 2400 and PerkinElmer 2410. It has a maximum inlet pressure of 3000psi and a CGA fitting size of 590, which is appropriate for air.

Samples can be rapidly and easily transferred from a wide variety of containers to the flowcell formeasurement. Includes: Flowcell, Square Section, Synthetic, Fused Silica, pathlength:1.

SLIDE ASSY-NEEDLE

The small-spot directional IV accessory is a modified version that has optics which are specially configured to measure small samples. Using this accessory, samples as small as 3 mm in height and 1 mm in width can be measured.

Precise, non-magnetic tips reliably contact smallest SMD. The Quick Test tweezers gives users an easy way to sort and evaluate loose components and to perform on-board measurements and debugging.

Sodium Chloride (NaCl) NaCl is one of the most versatile window materials available, due to its spectral range and low cost. Samples should not contain water because NaCl is hygroscopic.

Our Sodium Chloride Disk for the Microscope supports microsamples for infrared analysis, offering a wide spectral range at a low cost.

The pre-assembled Sodium Chloride Semi-Demountable Cell Kit from PerkinElmer is ideal for FT-IR analysis of high viscosity liquids and of mull samples.

Combining two different requirements into one cell allows a myriad of different sampling applications. Two cells in one- Demountable and Sealed Cell.

The pre-assembled Sodium Chloride Semi-Demountable Cell Kit from PerkinElmer is ideal for FT-IR analysis of high viscosity liquids and of mull samples.