Electronic Materials

Gold coated mica.

DescriptionFunctionalization agent: Octadecylamine.Solubility: Organic solvent.Thickness: 1-5 layers.Lateral size : 0.5-5 μm.Polymer filler to improve thermal, electrical and mechanical properties.Rubber filler to improve mechanical and gas barrier

DescriptionThickness: &lt:3 layers.Lateral size : 0.5-5 μm.Anti-corrosion coatings.Anti-static packaging-cement.Composites electronics.

DescriptionFunctionalization agent: KH-550.Solubility: Organic solvents.Thickness: 1-5 layers.Lateral size: 0.5-5 μm.Polymer filler to improve thermal, electrical and mechanical properties.Rubber filler to improve mechanical and gas barrier

DescriptionGraphene preparation method: electrochemical exfoliation.Graphene thickness by AFM: ∼80% 1-3 layers.Sheet size by AFM: 5-10 μm.Oxygen content: 5.5 at.% (C/O-ratio: 17.2).Raman I_D/I_G ratio: 0.25.Sheet resistance: 2 kΩ/sq.Typical

DescriptionPrepared by the exfoliation of graphite in aqueous solution using Pluronic®F87 as surfactant. Pluronic®F87 is one of nonionic, biocompatible block copolymers.

DescriptionGraphene preparation method: electrochemical exfoliation.Graphene thickness by AFM: 80%, 1-3 layers.Sheet size by AFM: 10 μm.Oxygen content: 7.5% (by XPS) (C/O-ratio: 12.3).Raman I_D/I_G ratio: 0.4.Sheet resistance: 4.8 kΩ/sq.Typical

DescriptionThe conductive graphene sheets can also be re-dispersed in other organic solvents such as ethanol, acetone, toluene and chloroform.No any surfactants or stabilizers exist on the graphene surface.Graphene-based

DescriptionDevice configuration:This Graphene FET chip provides 36 graphene devices distributed in a grid pattern on the chip. 30 devices have Hall-bar geometry and 6 have 2-probe geometry.The Hall-bar devices can be used for Hall measurements as

DescriptionGraphene FET chip (GFET-S20 chip) is a graphene based field effect transistor which can be coated on silicon substrate by atmospheric pressure chemical vapor deposition (CVD). It also has similar gate insulators in the source and

DescriptionFormulated with ethyl cellulose in cyclohexanone, terpineol, and diethylene glycol methyl ether for inkjet printing.Curing condition: Photonic annealing, &gt:4 J/cm2incident (Xe flash lamp) (substrate dependent - most effective for low

DescriptionGravure printable graphene dispersion has shown promising uses in printed and flexible electronics owning to its high speed and high resolution of deposition.Formulated for Gravure printing.Curing Condition: 250-350 °C, 20-30 min.