Small Flask Holder

Brushed stainless steel and glacier white, epoxy-coated steel exterior with blue accents. Acrylic lid or glass lid, depending on model Lid latch with safety sensor Phenol-free lid gasket Epoxy-coated aluminum chamber or Teflon-coated aluminum chamber with Hastelloy* shaft, depending on the model 300-watt heater to heat chamber to +100°C HCFC/CFC-free refrigeration system to cool chamber to -4°C. Sensor that reads chamber temperature. Microprocessor-controlled programming for "Temperature 1" from -4° C to +100° C, "Temperature 1" time from 1 to 999 minutes or indefinite, "Temperature 2" from -4° C to +100° C, and "Temperature 2" time from 0 to 999 minutes or indefinite. Memory stores 1 to 9 programs. LCD for display of program number, set point and actual "Temperature 1 and 2," set point and time remaining for "Temperature 1 and 2," and refrigeration activation ("Y" or "N") Control panel with RUN/STOP button, PREHEAT/ COOL button, set point SELECT button, increase/ decrease buttons, and 3 Quick-Start buttons. Centrifugal motion provided by a brushless motor capable of achieving up to 1725 rpm Quick-Stop System to stop vacuum pump, open valve to bleed air into the chamber and stop the rotor within seconds after time expires or RUN/STOP button is pressed Automatic vacuum release valve Built-in vacuum delay allows rotor to achieve speed before applying vacuum Audible alarm to signal completion of set point run time 1/2" OD aluminum hose fitting for connection to vacuum tubing. Vacuum pump is not included Vacuum port with quick disconnect fitting for 1/4" ID tubing. Electrical receptacle on the back to connect accessory vacuum pump to the system ETL & ETL-C listing on 115 volt & 230 volt, 60 Hz models CE mark on 230 volt, 50 Hz models Overall dimensions with closed lid: 14.3" wide x 21.7" deep x 16.6" high (36.4 x 55.1 x 42.2 cm) Actual weight 95 lbs. (43 kg). Shipping weight 108 lbs. (49 kg)